When conditions warrant, the height of the top edge may exceed the 45-inch height, provided the handrail system meets all other criteria.The top edge height of top rails on supported scaffolds must be between 36 inches and 45 inches.Each top rail or equivalent member of a handrail system must be able to withstand a force of at least 200 pounds applied in any downward or horizontal direction, at any point along its top edge.Walkways located within a scaffold must have handrail systems installed within 9½ inches of and along at least one side of the walkway.Handrail systems must be installed along all open sides and ends of platforms and must be in place before the scaffold is released for use by employees other than erection/dismantling crews.When horizontal lifelines are used, they are to be secured to two or more structural members of the scaffold.It is dangerous and therefore impermissible for two or more vertical lifelines to be attached to each other, or to the same point of anchorage.Safe points of anchorage include structural members of buildings, but not standpipes, vents, electrical conduit, etc., which may give way under the force of a fall. When vertical lifelines are used, they must be fastened to a fixed safe point of anchorage, independent of the scaffold, and be protected from sharp edges and abrasion.

502(d), personal fall-arrest systems used on scaffolds are to be attached by lanyard to a vertical lifeline, horizontal lifeline, or scaffold structural member. In addition to meeting the requirements of.Employers are required to provide fall protection for employees erecting or dismantling supported scaffolds where it is feasible, and where installing and using it does not create a greater hazard.Employees performing overhand bricklaying operations from a supported scaffold must be protected from falling from all open sides and ends of the scaffold, except at the side next to the wall being laid.Fall protection consists of either personal fall arrest systems or guardrail systems meeting OSHA requirements.Each employee on a scaffold more than 10 feet above a lower level must be protected from falling to that lower level.Specific requirements are described below. Fall protection consists of either personal fall-arrest systems or guardrail systems and must be provided on any scaffold 10 feet or more above a lower level. The number one scaffold hazard is worker falls. Fabricated Frame Scaffold Fall Protection They are frequently used in one or two tiers by residential contractors, painters, etc., but their modular frames and braces can also be stacked several stories high for use on large-scale construction jobs. Scaffolding In Placeįabricated frame scaffolds are the most common type of scaffolding because they are versatile, economical, and easy to use. There are more modern scaffolding options these days. Fabricated frame scaffold: A scaffold consisting of platforms supported on fabricated end frames with integral posts, horizontal bearers, and intermediate members.

Fabricated frame scaffold brackets